Basically it brings out the VCC, GND, RXD, TXD and DTR (via a 0.1 uF cap) pins to jumper cables.
I'll probably add some labels later.
|One end of the jumper cables permanently soldered to the jig and the other end resting in the perfboard holes.|
|Under the board is the pretty simple circuit with the oh so important 0.1 uF capacitor that goes between the ATmega reset pin and the FT232RL DTR pin.|
|Ready and hooked up to a ATmega328P on a breadboard.|
|The Sparkfun FT232RL break out board.|